Section 3 - Maintenance
Routine Maintenance
Hydraulic System
3-44 3-44
9803/9340-8
Changing the Hydraulic Filter
1 Stop the engine and wait for 5 minutes.
2 Loosen the breather cap C and allow all pressure to
dissipate.
K Fig 31. ( T 3-44)
3 Remove the filler cap B. K Fig 31. ( T 3-44)
4 Withdraw spring F and filter element D from the body.
5 Clean all metal parts. Reassemble using new filter
element D and new `O' ring E if necessary.
6 Add engine oil through filler point B
K Fluids,
Lubricants and Capacities ( T 3-11).
7 Refit cap B, run the engine for a few minutes, then re-
check the fluid level.
Fig 31.
Þ
Ú
Ü
Û
To Next Page
Loading...
