Section E - Hydraulics
E-155 E-155
9803-9340-8
Oil Cooler
Oil Cooler Connections
Removal and Replacement
If the oil cooler is removed or refitted, the following
procedure must be carried out to ensure that no damage is
caused to the fittings on the cooler.
When loosening or tightening the cooler hoses, ensure the
cooler adapter is held firm as shown. The hose connection
should be torque tightened to 20 Nm (2 kgf m, 15 lbf ft).
794030-1
Fig 1.
To Next Page
Loading...
