Section 3 - Maintenance
Routine Maintenance
Service Requirements
3-2 3-2
9803/9340-8
Initial Service and Inspection (250
Hours)
T3-006
To further protect your machine's performance it is
essential your JCB Distributor carries out an initial service
and inspection when the machine is three months old or
when it has completed 250 hours of operation (whichever
occurs first). You should notify your Distributor in advance
to allow the necessary arrangements to be made.
Lifting Regulations - Inspections and
Tests
T3-003
Only your JCB Distributor can fully meet the requirements
of the inspection and test parameters to suit UK Health and
Safety Executive (H.S.E.) legal requirements along with
providing Annual Inspections to meet your Insurance
Company Policy conditions.
Only your JCB Distributor has the ability to meet the
definition described covering a "Competent Person" to
carry out these necessary tests and inspections. This
ensures that only JCB Factory trained, experienced and
up-to-date Engineers supported with all of the available
data and material provided only to a JCB Distributor will
ensure a thorough and reliable standard.
Obtaining Replacement Parts
T3-004_2
We recommend you fit only JCB Genuine Parts. A Parts
Book will help you identify parts and order them from your
JCB distributor.
Your dealer will need to know the exact model, build and
serial number of your machine. See Identifying Your
Machine in INTRODUCTION section.
The data plate also shows the serial numbers of the
engine, transmission and axle(s), where applicable. But
remember if any of these units have been changed, the
serial number on the data plate may be wrong. Check on
the unit itself.
To Next Page
Loading...
