Section 2 - Care and Safety
Safety Notices
Safety Checklist
2-7 2-7
9803/9340-8
!M
DANGER
Forks/Working Platform
Using the forks alone as a working platform is
hazardous; you can fall off and be killed or injured.
Never use the forks as a working platform.
5-1-5-3
!MWARNING
Forks/Turning
The forks project in front of the machine. Make sure
there is enough clearance for the forks when making
turns.
5-1-5-4_2
Maintenance Safety
!M
WARNING
Communications
Bad communications can cause accidents. If two or
more people are working on the machine, make sure
each is aware of what the others are doing. Before
starting the engine make sure the others are clear of
the danger areas; examples of danger areas are: the
rotating blades and belt on the engine, the
attachments and linkages, and anywhere beneath or
behind the machine. People can be killed or injured if
these precautions are not taken.
INT-3-1-5
!M
WARNING
Repairs
If your machine does not function correctly in any way,
get it repaired straight away. Neglect of necessary
repairs could result in an accident or affect your
health. Do not try to do repairs or any other type of
maintenance work you do not understand. To avoid
injury and/or damage get the work done by a specialist
engineer.
GEN-1-5_2
!M
WARNING
Metal Splinters
You can be injured by flying metal splinters when
driving metal pins in or out. Use a soft faced hammer
or copper pin to remove and fit metal pins. Always
wear safety glasses.
INT-3-1-3_2
!M
WARNING
Electrical Circuits
Understand the electrical circuit before connecting or
disconnecting an electrical component. A wrong
connection can cause injury and/or damage.
INT-3-1-4
!MCAUTION
Do not disconnect the battery while the engine is
running, otherwise the electrical circuits may be
damaged.
INT-3-1-14
To Next Page
Loading...
