Section 3 - Maintenance
Routine Maintenance
Engine
3-33 3-33
9803/9340-8
Engine
Checking the Oil Level
!M
CAUTION
Hot oil and engine components can burn you. Make
sure the engine is cool before doing this job.
2-3-3-2
1 Park the machine on level ground and lower the
attachments to the ground.
2 Stop the engine and remove starter key.
3 Raise the engine cover
K Opening and Closing the
Engine Cover ( T 3-23).
4 Check that the oil level is within the marked area on
the dipstick A.
5 If necessary add the recommended oil through the
filler point B.
K Fluids, Lubricants and
Capacities ( T 3-11).
Fig 18.
6 Make sure the filler cap and the dipstick are secure.
7 Close the engine cover.
Changing the Oil and Filter
!M
WARNING
Oil
Oil is toxic. If you swallow any oil, do not induce
vomiting, seek medical advice. Used engine oil
contains harmful contaminants which can cause skin
cancer. Do not handle used engine oil more than
necessary. Always use barrier cream or wear gloves to
prevent skin contact. Wash skin contaminated with oil
thoroughly in warm soapy water. Do not use petrol,
diesel fuel or paraffin to clean your skin.
INT-3-2-3
!M
CAUTION
Oil will gush from the hole when the drain plug is
removed. Hot oil and engine components can burn
you. Keep to one side when you remove the plug.
13-3-1-15
1 Do steps 1 to 3 K Checking the Oil Level ( T 3-33)
2 Place a suitable container beneath the machine to
catch the oil.
3 Remove drain plug C and allow the oil to flow into the
container. K Fig 19. ( T 3-34)
4 After emptying the sump, replace the drain plug C.
707620
ß
Þ
To Next Page
Loading...
