jcb Mini CX - Page 94

Section 3 - Maintenance
Routine Maintenance
Engine
3-34 3-34
9803/9340-8
Fig 19.
5 Change the filter:
a Unscrew the filter canister D; remember that it will
be full of oil.
b Clean the filter head E.
c Add clean engine lubricating oil to the new filter
canister. Allow enough time for the oil to pass
through the filter element.
d Smear the seal F on the new filter with oil. Screw
in the new filter canister - hand tight only.
6 Fill the engine to the max mark on the dipstick with the
recommended oil through the filler
K Fluids,
Lubricants and Capacities ( T 3-11). Wipe off any
spilt oil. Check for leaks. Make sure the filler cap is
correctly fitted.
7 Make sure the engine will not start by removing the
engine shut-off solenoid (ESOS) fuse
K Fuses - Mini
CX ( T C-2)). Turn the engine using the starter key
until the oil pressure warning light is extinguished.
8 Refit the ESOS fuse and start the engine. Check for
leaks. When the engine has cooled, check the oil
level and, if necessary, top up with clean engine oil.
9 Close the engine cover.
707680
Ý
Ú
Û
Ü