Section 3 - Maintenance
Routine Maintenance
Greasing (10 Hours)
3-25 3-25
9803/9340-8
Greasing (10 Hours)
Introduction
T3-028
You must grease the machine regularly to keep it working
efficiently. Regular greasing will also lengthen the
machine's working life. Refer to the Service Schedule for
the correct intervals.
Note: The machine must always be greased after
pressure washing or steam cleaning.
Greasing should be done with a grease gun. Normally, two
strokes of the gun should be sufficient. Stop greasing when
fresh grease appears at the joint. Use only the
recommended type of grease. Do not mix different types of
grease, keep them separate.
In the following illustrations, the grease points are
numbered. Count off the grease points as you grease each
one. Refit the dust caps after greasing.
Note: Where applicable, refer to the manufacturers
manual for instructions on the maintenance of optional
attachments.
Loader Arm Pivot Points - Mini CX
Switch off the engine and ensure it cannot be started while
you are doing this job.
Note: Grease points 6, 11 and 12 are on the opposite side
of the machine.
Total 12 grease points.
Fig 8. Mini CX
708200
ï
îôê
í
ì é
è
ë
çôïï
ïðôïî
To Next Page
Loading...
