Section E - Hydraulics
E-99 E-99
9803-9340-8
Drive Motors
Axle Drive Motor
Removal and Replacement
Removal
Disconnect and plug the main feed hoses A and B from the
motor. Disconnect and plug the drain hose C from the
motor. Unscrew and remove bolts or cap screws D.
Withdraw the motor forwards clear of the drive splines.
Replacement
Replacement is the reversal of the removal procedure.
Apply JCB High Strength Threadlocker to bolts or cap
screws D before fitting K Sealing and Retaining
Compounds ( T 1-29). Tighten to the correct torque.
Torque Settings
707300-2
Fig 1.
Item Nm kgf m lbf ft
D Bolt (Hex. head) 74 7.5 55
D Cap screw 55 5.6 41
Ý
ß
Þ
Ü
Ü
To Next Page
Loading...
