Section F - Transmission
F-1 F-1
9803-9340-8
Wheels
Wheel Removal and Replacement
Removal
The procedure is the same for all four wheels.
!M
WARNING
A raised and badly supported machine can fall on you.
Position the machine on a firm, level surface before
raising one end. Ensure the other end is securely
chocked. Do not rely solely on the machine hydraulics
or jacks to support the machine when working under
it.
Disconnect the battery, to prevent the engine being
started while you are beneath the machine.
GEN-1-1
Slacken the wheel retaining nuts then raise and support
the ends of the machine on blocks.
Remove the wheel nuts and lift the wheel away from the
machine.
Replacement
Replacement is a reversal of hte removal procedure.
Tighten the wheel retaining nuts to the correct torque as
follows:
2 wheel drive machines 96 Nm (9.8 kgf m, 71 lbf ft)
4 wheel drive machines 200 Nm (20.4 kgf m, 147 lbf ft)
To Next Page
Loading...
