Section K - Engine
K-1 K-1
9803-9340-8
Technical Data
Technical Data up to machine no. 1042315
General Data
Speeds
Fuel System
Cooling System
Note: If during the life of a machine it is necessary to fit a
new engine, then after the first 50 operating hours a new
engine oil filter must be fitted and the engine oil changed.
Failure to complete this could damage the engine.
Note: Should further details be required, refer to Engine
Service Manual 9806/2100.
Model KD 103-10
Type 3 cylinder in-line, compression ignition, naturally aspirated
Engine Code KD 51135U
Bore (nominal) 75 mm (2.9 in)
Stroke 72 mm (2.8 in)
Swept Volume
954 cm
2
(58.2 in
3
)
Compression Ratio 23: 1
Injection Sequence 1,2,3
Valve Clearance - Cold - Inlet and Exhaust 0.2 mm (0.0078 in)
Oil Pressure
2.8 - 4.8 bar (42 - 71 lbf/in
2
)
Weight (dry) 111 kg (245 lb)
Rated Speed 2800 rev/min
Idling Speed 975 rev/min
Governing Mechanical
Static Timing 22º - 24º BTDC
Fan Type Mechanical
Coolant Pressure
1 bar (14.5 lbf/in
2
)
Thermostat operating temperature
- opens at 80 - 84 ºC (176 - 183 ºF)
- fully open at 95 ºC (202 ºF)
Temperature Warning Light operates
at 101 - 109 ºC (214 - 228 ºF)
To Next Page
Loading...
