Section 3 - Maintenance
Routine Maintenance
Service Schedules
3-7 3-7
9803/9340-8
Service Schedules
Introduction
A poorly maintained machine is a hazard. Doing the
regular maintenance and lubrication jobs listed in these
schedules will help keep the machine in safe running
order.
!MWARNING
Maintenance must be done only by suitably qualified
and competent persons.
Before doing any maintenance make sure the machine
is safe, it should be correctly parked on level ground.
To prevent anyone starting the engine, remove the
starter key. Disconnect the battery when you are not
using electrical power. If you do not take these
precautions you could be killed or injured.
8-3-1-1
Apart from the daily jobs, the schedules are based on
machine running hours. Keep a regular check on the hour
meter reading. Do not use a machine which is due for a
regular service. Rectify any defects found during regular
maintenance before clearing the machine for use.
All jobs should be marked and logged
K Table 1. ( T 3-7)
A Service History Record Book is supplied with every
machine to enable you to plan your service
requirements and keep a service history record. This
record book should be dated, signed and stamped by
your Distributor at machine installation and each time
your machine is serviced.
2-3-1-9
Note: Original copy to customer, Photocopy to distributor.
Table 1.
How to Use the Service Schedules
T3-012_3
In the example shown, A shows all service requirements to
be carried out every 10 hours and B shows the
requirements to be carried out every 500 hours.
Important: Services should be carried out at either the
hourly interval or calendar interval, whichever occurs first.
Refer to Calendar Equivalents.
795390-1
Calendar equivalents:
Every 10 Hours = Daily
Every 50 Hours = Weekly
Every 500 Hours = Six Months
Every 1000 Hours = 1 Year
Every 2000 Hours = 2 Year
Description Symbol
No fault found job complete
Fault found and corrected (Detail on report)
Follow up required (Detail on report)
To Next Page
Loading...
