Section 2 - Care and Safety
Safety Notices
Safety Checklist
2-6 2-6
9803/9340-8
!M
WARNING
Electrical Power Cables
You could be electrocuted or badly burned if you get
the machine or its attachments too close to electrical
power cables.
You are strongly advised to make sure that the safety
arrangements on site comply with the local laws and
regulations concerning work near electric power lines.
Before you start using the machine, check with your
electricity supplier if there are any buried power
cables on the site.
There is a minimum clearance required for working
beneath overhead power cables. You must obtain
details from your local
electricity supplier.
2-2-5-4
!MCAUTION
If you have an attachment which is not covered in the
Operator Manual do not install it, use it or remove it
until you have obtained, read and understood the
pertinent information. Install attachments only on the
machines for which they were designed.
5-5-1-1_2
!M
WARNING
Use only the JCB approved attachments that are
specified for your machine. Operating with non-
specified attachments can overload the machine,
causing possible damage and machine instability
which could result in injury to yourself or others.
The use of non-approved attachments could invalidate
your warranty.
2-4-5-2_1
!M
CAUTION
If you have an attachment which is not covered in the
Operator Manual do not install it, use it or remove it
until you have obtained, read and understood the
pertinent information. Install attachments only on the
machines for which they were designed.
5-5-1-1_2
!M
CAUTION
Fork Spacing
Loads can fall off incorrectly spaced forks. Always
space the forks correctly for the load. Make sure the
forks are completely under the load before lifting.
5-1-4-2
!MCAUTION
One-Fork Lifting
A load lifted on one fork can slip off. Never lift a load
with one fork.
5-1-4-3
!M
CAUTION
Unloading
Never unload the forks by stopping the machine
suddenly. Follow the procedures in the Operator
Manual for unloading.
5-1-4-4_2
!M
CAUTION
Uneven Ground
Loads stacked on uneven ground can topple. Never
stack loads on uneven ground.
5-1-4-5
!M
WARNING
Scaffolding
Overloaded scaffolding can collapse. Never load
scaffolding beyond the regulation capacity.
5-1-4-6
!M
CAUTION
Overhead Clearance
A raised mast can strike overhead objects. Always
check for overhead clearance before raising the mast.
9-1-3-1
!M
WARNING
Mast/Travelling
Operating the mast and carriage while travelling can
cause accidents. You will not have total control. Never
operate the mast and carriage while travelling.
9-1-3-2
To Next Page
Loading...
