Section E - Hydraulics
Pumps
Pump Assembly Series 1 Machines
E-74 E-74
9803-9340-8
Replacement
Using suitable lifting equipment carefully lower the pump
unit into position. Offer the drive shaft through the flywheel
aperture and locate the splines into the engine drive
coupling. It may be necessary to rock the pump unit from
side to side to engage the splines.
Fit the two securing bolts H.
Reconnect the motor feed hoses D and E and the charge
pump suction hose C.
Reconnect the service pump pressure hose B and suction
hose A.
Refit the cable and damper bracket to the pump.
Connect the cable and damper to the pump operating lever
at F. It may be necessary to adjust the cable
K Transmission Pump Neutral Adjustment - Series 1
Machines ( T E-62).
Refill the hydraulic tank and refit the filler cap.
Prime the system
K Start-up Procedure - Series 1
Machines ( T E-95).
Refit the front floor plates.
To Next Page
Loading...
