jcb Mini CX - Page 283

Section E - Hydraulics
Drive Motors
Wheel Drive Motors
E-113 E-113
9803-9340-8
22 Install the snap ring in line with the mark made during
dismantling
K Fig 39. ( T E-113).
865940C
Fig 39.
23 Apply hydraulic pressure to the brake and re-check
the piston stroke K Fig 40. ( T E-113).
865940D
Fig 40.
24 Coat new ‘O’ ring (143) with antioxidising grease and
install into its groove
K Fig 41. ( T E-113).
865950A
Fig 41.
25 Install a new cover (141) on the entry chamfer
K Fig 42. ( T E-113).
865950B
Fig 42.
26 Click the cover into place using the appropriate
mandrel. Make sure the outer edge of the cover is
engaged in the groove
K Fig 43. ( T E-113).
865950C
Fig 43.
27 Install a new plug (142)
K Fig 44. ( T E-114).
ïìí
ïìï