Section 3 - Maintenance
Routine Maintenance
Cleaning the Machine
3-17 3-17
9803/9340-8
Cleaning the Machine
!M
WARNING
To avoid burning, wear protective gloves when
handling hot components. To protect your eyes, wear
goggles when using a wire brush to clean
components.
HYD-1-3
!M
WARNING
Airborne particles of light combustible material such
as straw, grass, wood shavings, etc. must not be
allowed to accumulate within the engine compartment
or in the propshaft guards (when fitted). Inspect these
areas frequently and clean at the beginning of each
work shift or more often if required. Before opening
the engine cover, ensure that the top is clear of debris.
5-3-1-12_3
1 If the radiator tubes/fins get clogged the radiator will
be less efficient.
Make sure that the radiator is not blocked.
2 Engine.
Do not let mud build-up on the engine or the
transmission system.
Remove all flammable material from the exhaust
area.
High pressure wash systems can cause damage to
the engine and some components. Be careful when
this system is used.
Important: Do not put the jet nozzle closer than 600 mm
(24 in.) to any part of the engine.
3 Pay particular attention to the underside. Do not allow
mud to build up. Make sure the radiator grille is not
clogged up
K Cleaning the Coolant
Radiator ( T 3-37)
To Next Page
Loading...
