jcb Mini CX - Page 82

Section 3 - Maintenance
Routine Maintenance
Loader Arm Safety Strut
3-22 3-22
9803/9340-8
Fig 3.
b Place the strut around one of the lift rams.
c Secure the strut A into position using strap B.
5 Start the engine.
6 Slowly lower the loader arms onto the safety strut.
Stop the movement immediately the weight of the
arms is supported by the strut.
Note: Extreme care must be taken when lowering the
loader arms onto the safety strut. 'Feather' the lever to
lower the loader arms slowly.
Removing the Safety Strut
!M
WARNING
You could be killed or injured if the loader control is
accidentally operated. Make sure no-one comes near
the machine while you remove the safety strut.
2-3-1-3
1 Raise the loader arms to take the weight off the safety
strut A. Stop the engine.
2 Take care not to stand directly under any raised part
of the machine.
3 Remove the strut:
a Release securing strap B.
b Remove the safety strut from the lift ram.
c Return the safety strut to its stowage position C.
K Fig 1. ( T 3-21) or K Fig 2. ( T 3-21)
708100
ß
Þ