GETTING TO KNOW YOUR VEHICLE 105
9. Remove the hard top from the vehicle. Install the edge
protectors and place the hard top on a soft surface to
prevent damage.
Rear Hard Top Installation
NOTE:
If the door frames are installed from soft top usage, they
must
be removed prior to installation of the hard top. Refer
to “Door Frame” in this section for removal procedures.
1. Inspect the hard top seals for damage and replace if
nec
essary.
2. Install the hard top using the same steps for removal in
rev
erse order.
NOTE:
When reinstalling the interior soft trim panel:
• Be sure the panel is centered so that there is an even gap on
bot
h sides.
• Apply pressure over the hook-and-loop fasteners to
ens
ure they are properly secured.
3. Make sure that the hard top is sitting flush with the body
at
the sides and across the back.
NOTE:
The Torx fasteners that attach the hard top to the body
shou
ld be torqued to 155 in-lb +/- 22 in-lb (17.5 N·m +/-
2.5 N
·m) using the provided #T50 Torx head driver and
ratc
het.
CAUTION!
The removal of the hard top requires four adults located
on
ea
ch corner. Failure to follow this caution could
damage the hard top.
CAUTION!
Do not overtighten Torx fasteners. Damage to the
reta
iners will occur.
2
To Next Page
Loading...
