Jeep Gladiator 2020 - To Exit Remote Start Mode and Drive the Vehicle; Remote Start Comfort Systems - if Equipped; General Information

GETTING TO KNOW YOUR VEHICLE 29
To Exit Remote Start Mode And Drive The Vehicle
Before the end of 15-minute cycle, push and release the
unlock button on the key fob to unlock the doors, or unlock
the vehicle using Keyless Enter-N-Go — Passive Entry via
the door handles, and disarm the Vehicle Security Alarm (if
equipped). Then, prior to the end of the 15-minute cycle,
push and release the START/STOP Ignition Button.
NOTE:
For vehicles equipped with the Keyless Enter-N-Go —
P
ass
ive Entry feature, the message “Remote Start Active —
Push Start Button” will display in the instrument cluster
display until you push the START/STOP Ignition Button.
Remote Start Comfort Systems — If Equipped
When Remote Start is activated, the Climate Controls may
activate the heated seats (if equipped) and heated steering
wheel (if equipped) in temperatures below 40°F (4.4°C).
These features will stay on through the duration of Remote
Start or until the ignition switch is cycled to the ON/RUN
position.
General Information
The following regulatory statement applies to all Radio
Frequency (RF) devices equipped in this vehicle:
This device complies with Part 15 of the FCC Rules and with
Inno
vation, Science and Economic Development Canada
license-exempt RSS standard(s). Operation is subject to the
following two conditions:
1. This device may not cause harmful interference, and
2. T
his device must accept any interference received,
inc
luding interference that may cause undesired opera-
tion.
Le présent appareil est conforme aux CNR d`Innovation,
S
cie
nce and Economic Development applicables aux appar-
eils radio exempts de licence. L'exploitation est autorisée aux
d
eux
conditions suivantes:
1. l'appareil ne doit pas produire de brouillage, et
2. l
'utilisateur de l'appareil doit accepter tout brouillage
rad
ioélectrique subi, même si le brouillage est susceptible
d'en compromettre le fonctionnement.
2