Jeep Gladiator 2020 - Parkview Rear Back up Camera

356 STARTING AND OPERATING
PARKVIEW REAR BACK UP CAMERA
The ParkView Rear Back Up Camera allows you to see an
on-screen image of the rear surroundings of your vehicle
whenever the gear selector is in REVERSE. The image will be
displayed in the touchscreen display along with a caution
note to “check entire surroundings” across the top of the
screen. After five seconds this note will disappear. The
ParkView camera is located on the tailgate, above the vehicle
license plate.
Manual Activation Of The Rear View Camera
1. Go to the Controls screen by pressing the “Controls”
but
ton located on the bottom of the Uconnect display,
and then press “Backup Camera”.
2. Press the “Backup Camera” button to turn the Rear View
Cam
era system on.
NOTE:
For vehicles equipped with the Uconnect 3 With 5-Inch
Disp
lay, there is only one option for manual activation of the
Rear View Camera. Press the “More” hard button on the
Uconnect system, and then press “Backup Camera”.
When the vehicle is shifted out of REVERSE (with Camera
dela
y turned off), the rear Camera mode is exited and the
previous screen appears again.
When the vehicle is shifted out of REVERSE (with Camera
dela
y turned on), the rear Camera image will be displayed
for up to 10 seconds unless the vehicle speed exceeds 8
mph
(13
km/h), the transmission is shifted into PARK, the igni-
tion is cycled to the OFF position, or the touchscreen button
“
X”
to disable display of the Rear View Camera image is
pressed.
CAUTION!
• ParkSense is only a parking aid and it is unable to
rec
ognize every obstacle, including small obstacles.
Parking curbs might be temporarily detected or not
detected at all. Obstacles located above or below the
sensors will not be detected when they are in close
proximity.
• The vehicle must be driven slowly when using Park-
Sen
se in order to be able to stop in time when an
obsta
cle is detected. It is recommended that the driver
looks over his/her shoulder when using ParkSense.