422 IN CASE OF EMERGENCY
Reinstalling The Jack And Tools
1. Tighten the jack all the way down by turning the jack
turn-screw counterclockwise until the jack is snug.
2. Position the jack and tool bag. Make sure the lug wrench
is u
nder the jack near the jack turn-screw.
Jack And Tool Bag
3. Secure the tool bag straps to the jack.
4. Pl
ace the jack and tools in the storage position holding the
jack
by the jack turn-screw, place the jack and tools under
the rear seat.
5. Turn the wing bolt clockwise to secure to the floor pan.
Jack
Hold Down Wing Bolt
WARNING!
After using the jack and tools, always reinstall them in
the or
iginal carrier and location. While driving you may
experience abrupt stopping, rapid acceleration or sharp
turns. A loose jack, tools or bracket or other objects in the
vehicle may move around with force, resulting in serious
injury.
To Next Page
Loading...
