GETTING TO KNOW YOUR VEHICLE 139
Reprogramming A Single HomeLink® Button (Non-
Rolling Code)
To reprogram a channel that has been previously trained,
foll
ow these steps:
1. Cycle the ignition to the ON/RUN position.
2. P
ress and hold the desired HomeLink® button until the
ind
icator light begins to flash after 20 seconds. Do not
release the button.
3. Without releasing the button, proceed with “Program-
min
g A Non-Rolling Code” step 2 and follow all
rema
ining steps.
Canadian/Gate Operator Programming
For programming transmitters in Canada/United States that
require the transmitter signals to “time-out” after several
seconds of transmission.
Canadian radio frequency laws require transmitter signals to
time
-out (or quit) after several seconds of transmission –
which may not be long enough for HomeLink® to pick up
the signal during programming. Similar to this Canadian
law, some U.S. gate operators are designed to time-out in the
same manner.
It may be helpful to unplug the device during the cycling
proc
ess to prevent possible overheating of the garage door or
gate motor.
1. Cycle the ignition to the ON/RUN position.
2. P
lace the hand-held transmitter 1 to 3 in
ches (3 to 8 cm)
away from the HomeLink® button you wish to program
while keeping the HomeLink® indicator light in view.
3. Continue to press and hold the HomeLink® button, while
you
press and release (“cycle”) your hand-held trans-
mitter every two seconds until HomeLink® has success-
fully accepted the frequency signal. The indicator light
wi
ll
flash slowly and then rapidly when fully trained.
4. Watch for the HomeLink® indicator to change flash
rat
es. When it changes, it is programmed. It may take
up to 30 seconds or longer in rare cases. The garage
door may open and close while you are programming.
5. Press and hold the programmed HomeLink® button and
obs
erve the indicator light.
2
To Next Page
Loading...
