136 GETTING TO KNOW YOUR VEHICLE
Before You Begin Programming HomeLink®
Be sure that your vehicle is parked outside of the garage
before you begin programming.
For more efficient programming and accurate transmission
of th
e radio-frequency signal it is recommended that a new
battery be placed in the hand-held transmitter of the device
that is being programmed to the HomeLink® system. Make
sure your hand-held transmitter is programmed to activate
the device you are trying to program your HomeLink®
button to.
To erase the channels, place the ignition in the ON/RUN
posit
ion, and push and hold the two outside HomeLink®
buttons (I and III) for up to 20 seconds or until the orange
indicator flashes.
NOTE:
• E
rasing all channels should only be performed when
progr
amming HomeLink® for the first time. Do not erase
channels when programming additional buttons.
• If you have any problems, or require assistance, please call
toll
-free 1-800-355-3515 or, on the Internet at Home-
Link.com for information or assistance.
Programming A Rolling Code
Programming garage door openers that were manufactured
a
fter
1995 can be identified by the “LEARN” or “TRAIN”
button located where the hanging antenna is attached to the
garage door opener.
NOTE:
It is NOT the button that is normally used to open and close
t
he d
oor. The name and color of the button may vary by
manufacturer.
Training The Garage Door Opener
1 — Door Opener
2 — Training Button
To Next Page
Loading...
