EasyManua.ls Logo

Jeep Gladiator 2020 - To Start the Engine While in Autostop Mode; To Manually Turn off the Stop;Start System

Jeep Gladiator 2020
670 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
STARTING AND OPERATING 313
To Start The Engine While In Autostop Mode
While in a forward gear, the engine will start when the brake
pedal is released or the throttle pedal is depressed. The trans-
mission will automatically re-engage upon engine restart.
Conditions That Will Cause The Engine To Start Automat-
ically While In Autostop Mode:
• T
he transmission selector is moved out of DRIVE
• To m
aintain cabin temperature comfort
• Actu
al cabin temperature is significantly different than
temp
erature set on Auto HVAC
• HVAC is set to full defrost mode
• HVAC
system temperature or fan speed is manually adjusted
• Batt
ery voltage drops too low
• Low b
rake vacuum (e.g. after several brake pedal applica-
tion
s)
• S
TOP/START OFF switch is pushed
• A St
op/Start system error occurs
• STOP
/START AUTO STOP ACTIVE time exceeds 5 minu
tes
• 4WD system is put into 4L or Neutral mode
• Stee
ring wheel is turned beyond threshold
To Manually Turn Off The Stop/Start System
1. Push the STOP/START OFF switch (located on the
switch bank). The light on the switch will illuminate.
STOP/START Off Switch
2. T
he “STOP/START OFF” message will appear in instru-
ment
cluster display within the Stop/Start section. Refer
to “I
nstrument Cluster” in “Getting To Know Your
Instrument Panel” for further information.
3. At the next vehicle stop (after turning off the STOP/
STAR
T system), the engine will not be stopped.
4. The Stop/Start system will reset itself back to an ON condi-
tion
every time the ignition is turned off and back on.
5

Table of Contents