306 STARTING AND OPERATING
This feature will only activate when the following conditions
are met:
• Ignition in RUN position, vehicle in 4L (Low) range.
• Vehi
cle speed should be 10 mph
(16 km/h) or less.
• Both right and left wheels on axle are at the same speed.
To a
ctivate the system, push the AXLE LOCK switch down
to lo
ck the rear axle only (the “REAR ONLY” will illumi-
nate), push the switch up to lock the front axle and rear axle
(
the
“FRONT + REAR” will illuminate). When the rear axle
is locked, pushing the bottom of switch again will lock or
unlock the front axle.
NOTE:
The indicator lights will flash until the axles are fully locked
o
r un
locked.
To unlock the axles, push the AXLE LOCK OFF button.
Axle lock will disengage if the vehicle is taken out of 4L
(Low)
range, or the ignition switch is turned to the OFF posi-
tion.
The axle lock disengages at speeds above 30 mph (48 km/h),
a
nd wi
ll automatically re-lock once vehicle speed is less than
10
mph (16 km/h).
Electronic Sway Bar Disconnect — If Equipped
Your vehicle may be equipped with an electronic discon-
necting stabilizer/sway bar. This system allows greater front
suspe
nsion travel in off-road situations.
This system is controlled by the SWAY BAR switch located
on th
e instrument panel (to the right of the steering column).
Sway Bar Switch
Push the SWAY BAR switch to activate the system. Push the
switch
again to deactivate the system. The “Sway Bar Indi-
cator Light” (located in the instrument cluster) will illumi-
nate when the bar is disconnected. The “Sway Bar Indicator
To Next Page
Loading...
