Jeep Gladiator 2020 - Overtake Aid; ACC Operation at a Stop (Automatic Transmission Only)

STARTING AND OPERATING 331
Brake Alert
NOTE:
The “BRAKE!” screen in the instrument cluster display is a
warnin
g for the driver to take action and does not necessarily
mean that the Forward Collision Warning system is
applying the brakes autonomously.
Overtake Aid
When driving with ACC engaged and following a vehicle,
the system will provide an additional acceleration up to the
ACC set speed to assist in passing the vehicle. This addi
-
tional acceleration is triggered when the driver utilizes the
left
turn signal and will only be active when passing on the
left hand side.
ACC Operation At A Stop (Automatic Transmission
Only)
In the event that the ACC system brings your vehicle to a
standstill while following a target vehicle, your vehicle will
resume motion without the need for any driver action if the
target vehicle starts moving within two seconds of your
vehicle coming to a standstill.
If the target vehicle does not start moving within two
secon
ds of your vehicle coming to a standstill, the ACC with
Stop system will cancel and the brakes will release. A cancel
message will display on the instrument cluster display and
produce a warning chime. Driver intervention will be
required at this moment.
While ACC with Stop is holding your vehicle at a standstill,
if th
e driver seatbelt is unbuckled or the driver door is
opened, the ACC with Stop system will cancel and the brakes
will release. A cancel message will display on the instrument
cluster display and produce a warning chime. Driver inter
-
vention will be required at this moment.
5