Jeep Gladiator 2020 - Auxiliary Switches - if Equipped

152 GETTING TO KNOW YOUR VEHICLE
NOTE:
400 W is the maximum for the inverter, not each outlet. If two
outle
ts are in use, 400 W is shared amongst the devices
plugged in.
The power inverter is designed with built-in overload
prote
ction. If the power rating of 400 W is exceeded, the
power inverter automatically shuts down. Once the electrical
device has been removed from the outlet, the inverter should
automatically reset.
NOTE:
• The Power Inverter will only turn on if the ignition is in the
ACC
or ON/RUN position.
• Due to built-in overload protection, the power inverter
will
turn off if the power rating is exceeded.
Auxiliary Switches — If Equipped
Four auxiliary switches are located in the lower switch bank
of the instrument panel and can be used to power various
electrical devices.
The functionality of the auxiliary switches can be changed
via t
he Uconnect settings. All switches can be configured for
setting the switch type operation to latching or momentary,
power source of either battery or ignition, and ability to hold
last state across key cycles.
Auxiliary Switches
WARNING!
To avoid serious injury or death:
• D
o not insert any objects into the receptacles.
• Do not
touch with wet hands.
• Close
the lid when not in use.
• If t
his outlet is mishandled, it may cause an electric
shock
and failure.