GETTING TO KNOW YOUR VEHICLE 141
(Continued)
Troubleshooting Tips
If you are having trouble programming HomeLink®, here
are some of the most common solutions:
• Replace the battery in the garage door opener hand-held
tra
nsmitter.
• Push the LEARN button on the garage door opener to
com
plete the training for a Rolling Code.
• Did you unplug the device for programming and
rem
ember to plug it back in?
If you have any problems, or require assistance, please call
toll
-free 1-800-355-3515 or, on the Internet at HomeLink.com
for information or assistance.
General Information
The following regulatory statement applies to all Radio
Frequency (RF) devices equipped in this vehicle:
This device complies with Part 15 of the FCC Rules and with
Inno
vation, Science and Economic Development Canada
license-exempt RSS standard(s). Operation is subject to the
following two conditions:
1. This device may not cause harmful interference, and
2. T
his device must accept any interference received, including
int
erference that may cause undesired operation.
WARNING!
• Vehicle exhaust contains carbon monoxide, a
dan
gerous gas. Do not run your vehicle in the garage
while programming the transceiver. Exhaust gas can
cause serious injury or death.
• Your motorized door or gate will open and close while
you are programming the universal transceiver. Do not
program the transceiver if people, pets or other objects
are in the path of the door or gate. Only use this trans
-
ceiver with a garage door opener that has a “stop and
rever
se” feature as required by Federal safety stan-
dards. This includes most garage door opener models
m
anu
factured after 1982. Do not use a garage door
opener without these safety features. Call toll-free
1-800-355-3515 or, on the Internet at
HomeLink.com for
safety information or assistance.
WARNING! (Continued)
2
To Next Page
Loading...
