GETTING TO KNOW YOUR VEHICLE 31
Customer Key Programming
Programming key fobs may be performed at an authorized
dealer.
Replacement Keys
NOTE:
Only key fobs that are programmed to the vehicle electronics
can
be used to start and operate the vehicle. Once a key fob
is programmed to a vehicle, it cannot be programmed to any
other vehicle.
NOTE:
Duplication of key fobs may be performed at an authorized
d
eal
er. This procedure consists of programming a blank key
fob to the vehicle electronics. A blank key fob is one that has
never been programmed.
When having the Sentry Key Immobilizer System serviced,
brin
g all vehicle keys with you to an authorized dealer.
General Information
The following regulatory statement applies to all Radio
Frequency (RF) devices equipped in this vehicle:
This device complies with Part 15 of the FCC Rules and with
I
n
no
vation, Science and Economic Development Canada
license-exempt RSS standard(s). Operation is subject to the
following two conditions:
1. This device may not cause harmful interference, and
2. T
his device must accept any interference received,
inc
luding interference that may cause undesired opera-
tion.
Le présent appareil est conforme aux CNR d`Innovation,
S
cie
nce and Economic Development applicables aux appar-
eils radio exempts de licence. L'exploitation est autorisée aux
d
eux
conditions suivantes:
1. l'appareil ne doit pas produire de brouillage, et
2. l
'utilisateur de l'appareil doit accepter tout brouillage
radioélectrique subi, même si le brouillage est susceptible
d'en compromettre le fonctionnement.
CAUTION!
• A
lways remove the key fobs from the vehicle and lock
all
doors when leaving the vehicle unattended to
prevent theft and/or damage.
• Always remember to cycle the ignition to OFF to
pre
vent battery drainage.
2
To Next Page
Loading...
