Jeep Gladiator 2020 - To Vary the Speed Setting

STARTING AND OPERATING 327
• ACC cannot be resumed if there is a stationary vehicle
in-front of your vehicle in close proximity.
To Vary The Speed Setting
To Increase Speed
While ACC is set, you can increase the set speed by pushing
the
SET (+) button.
The driver's preferred units can be selected through the
inst
rument panel settings. Refer to “Getting To Know Your
Instrument Panel” for more information. The speed incre
-
ment shown is dependant on the chosen speed unit of U.S.
(mph
) or Metric (km/h):
U.S. Speed (mph)
• P
ushing the SET (+) b
utton once will result in a 1 mph
increase in set speed. Each subsequent tap of the button
results in an increase of 1
mph.
• If the button is continually pushed, the set speed will
con
tinue to increase in 5 mph increments until the button
is r
eleased. The increase in set speed is reflected in the
instrument cluster display.
Metric Speed (km/h)
• Pushing the SET (+) b
utton once will result in a 1 km/h
increase in set speed. Each subsequent tap of the button
results in an increase of 1
km/h.
• If the button is continually pushed, the set speed will
con
tinue to increase in 10 km/h increments until the
butt
on is released. The increase in set speed is reflected in
the instrument cluster display.
WARNING!
The Resume function should only be used if traffic and
road
conditions permit. Resuming a set speed that is too
high or too low for prevailing traffic and road conditions
could cause the vehicle to accelerate or decelerate too
sharply for safe operation. Failure to follow these
warnings can result in a collision and death or serious
personal injury.
5