GETTING TO KNOW YOUR VEHICLE 137
1. Place the ignition in the ON/RUN position.
2. Place the hand-held transmitter 1 to 3 in
ches (3 to 8 cm)
away from the HomeLink® button you wish to program
while keeping the HomeLink® indicator light in view.
3. Push and hold the HomeLink® button you want to
pro
gram while you push and hold the hand-held trans-
mitter button.
4. C
ontinue to hold both buttons and observe the indicator
ligh
t. The HomeLink® indicator will flash slowly and
then rapidly after HomeLink® has received the
frequency signal from the hand-held transmitter. Release
both buttons after the indicator light changes from slow
to rapid.
5. At the garage door opener motor (in the garage), locate
the
“LEARN” or “TRAIN” button. This can usually be
found where the hanging antenna wire is attached to the
garage door opener/device motor. Firmly push and
release the “LEARN” or “TRAIN” button. On some
garage door openers/devices there may be a light that
blinks when the garage door opener/device is in the
LEARN/TRAIN mode.
NOTE:
You have 30 seconds in which to initiate the next step after
the
LEARN button has been pushed.
6. Return to the vehicle and push the programmed Home-
Lin
k® button twice (holding the button for two seconds
each
time). If the garage door opener/device activates,
programming is complete.
To program the remaining two HomeLink® buttons, re-
peat each step for each remaining button. DO NOT erase
t
he
channels.
NOTE:
If the garage door opener/device does not activate, push the
b
utt
on a third time (for two seconds) to complete the
training.
2
To Next Page
