SAFETY 199
(Continued)
ESC uses sensors in the vehicle to determine the vehicle path
intended by the driver and compares it to the actual path of
the vehicle. When the actual path does not match the
intended path, ESC applies the brake of the appropriate
wheel to assist in counteracting the oversteer or understeer
condition.
• Oversteer — when the vehicle is turning more than appro-
pri
ate for the steering wheel position.
• U
ndersteer — when the vehicle is turning less than appro-
pri
ate for the steering wheel position.
The “ESC Activation/Malfunction Indicator Light” located
in t
he instrument cluster will start to flash as soon as the ESC
system becomes active. The “ESC Activation/Malfunction
Indicator Light” also flashes when the Traction Control
System (TCS) is active. If the “ESC Activation/Malfunction
Indicator Light” begins to flash during acceleration, ease up
on the accelerator and apply as little throttle as possible. Be
sure to adapt your speed and driving to the prevailing road
conditions.
WARNING!
• Electronic Stability Control (ESC) cannot prevent the
nat
ural laws of physics from acting on the vehicle, nor
can it increase the traction afforded by prevailing road
conditions. ESC cannot prevent accidents, including
those resulting from excessive speed in turns, driving
on very slippery surfaces, or hydroplaning. ESC also
cannot prevent accidents resulting from loss of vehicle
control due to inappropriate driver input for the condi
-
tions. Only a safe, attentive, and skillful driver can
p
reve
nt accidents. The capabilities of an ESC equipped
vehicle must never be exploited in a reckless or
dangerous manner which could jeopardize the user’s
safety or the safety of others.
4
To Next Page
Loading...
