GETTING TO KNOW YOUR VEHICLE 21
2. Remove the depleted battery by inserting a small
flat-blade screwdriver into the battery removal slot and
sliding the battery forward and upward being careful not
to damage the electronic board underneath.
Battery Replacement
3. Install the new battery into the key fob, making sure the
posi
tive (+) side is facing up. Slide the battery until it is
seated securely below the tabs.
4. Reassemble the back cover making sure it is properly
align
ed before snapping it back in place.
Programming Additional Key Fobs
Programming the key fob may be performed by an autho-
rized dealer.
NOTE:
Once a key fob is programmed to a vehicle, it cannot be
r
epur
posed and reprogrammed to another vehicle.
Request For Additional Key Fobs
NOTE
:
Only key fobs that are programmed to the vehicle electronics
can b
e used to start and operate the vehicle. Once a key fob
is programmed to a vehicle, it cannot be programmed to any
other vehicle.
Duplication of key fobs may be performed at an authorized
deale
r. This procedure consists of programming a blank key
fob to the vehicle electronics. A blank key fob is one that has
never been programmed.
WARNING!
• Always remove the key fobs from the vehicle and lock
all
doors when leaving the vehicle unattended.
• Always remember to place the ignition in the OFF
mode.
2
To Next Page
Loading...
