272 SAFETY
The seat belts in the passenger seating positions are
equipped with a Switchable Automatic Locking Retractor
(ALR) that is designed to keep the lap portion of the seat belt
tight around the child restraint so that it is not necessary to
use a locking clip. The ALR retractor can be “switched” into
a locked mode by pulling all of the webbing out of the
retractor and then letting the webbing retract back into the
retractor. If it is locked, the ALR will make a clicking noise
while the webbing is pulled back into the retractor.
Refer to the “Automatic Locking Mode” description in
“Switc
hable Automatic Locking Retractors (ALR)” under
“Occupant Restraint Systems” for additional information on
ALR.
Please see the table below and the following sections for
more
information.
Lap/Shoulder Belt Systems For Installing Child
Restraint
s In This Vehicle
Automatic Locking Retractor Locations
WARNING!
• Improper installation or failure to properly secure a
chil
d restraint can lead to failure of the restraint. The
child could be badly injured or killed.
• Follow the child restraint manufacturer’s directions
exac
tly when installing an infant or child restraint.
ALR = Switchable Automatic Locking Retractor
Top Tether Anchorage Symbol
To Next Page
Loading...
