STARTING AND OPERATING 359
“Uconnect Settings” in “Multimedia” for further informa-
tion.
Manual Activation Of The TrailCam
TrailCam View can be activated via the below methods:
1. P
ress the “FWD Camera” button on the controls screen.
2. P
ress the “FWD Camera” button on the app menu.
3. P
ress the “FWD Camera” button on the Off Road Pages.
4. A
uto Launch Off Road+ Setting is selected under camera
set
tings and press the “Off Road+” button.
The TrailCam View can also be activated via “FWD Camera”
butt
on on the Backup Camera View. The Backup Camera
View can also be activated via the “Backup Camera” button
on the TrailCam View.
When the vehicle is shifted out of REVERSE (with Camera
Dela
y turned off) and TrailCam View is active, the TrailCam
mode is exited and the previous screen appears again.
When the vehicle is shifted out of REVERSE (with Camera
Dela
y turned on) and the TrailCam View is active, the
TrailCam image will be displayed for up to 10 seconds unless
the vehicle speed exceeds 8
mph (13 km/h), the transmission
is s
hifted into PARK, the ignition is cycled to the OFF posi-
tion, or the touchscreen button “X” to disable display of the
Trai
lCam View is pressed.
Whenever the TrailCam image is activated through the
Manu
al Activation Methods, and the vehicle speed is greater
than or equal to 8
mph (13 km/h), a display timer for the
image
is initiated. The image will continue to be displayed
until the display timer exceeds 10 seconds.
NOTE:
• If the vehicle speed remains below 8 mp
h (13 km/h) while
in 2WD or 4H, the TrailCam image will be displayed
continuously until deactivated via the touchscreen button
“X”, the transmission is shifted into PARK, or the ignition
is cycled to the OFF position.
• The touchscreen button “X” to disable the display of the
cam
era image is made available ONLY when the vehicle is
not in reverse.
• The TrailCam View will stay active regardless of the
veh
icle speed and time while in 4L (Four-Wheel Drive
Low Range).
5
To Next Page
Loading...
