Operation Manual
INDEX-2
Packing Replacement 52
Inspection 55
Installation 56
Removal 52
Rupture Disc Inspection 52
Uni-Valve Service 58
Removal 58
Power End 70
Adjusting Belt Tension 73
Changing PTO Oil 72
Changing the Power End Oil 71
Charge Pump 74
Installation 74
Removal 74
Checking Belt Tension 72
Checking Power End Oil Level 70
Alternate Oil Check Methods 70
Checking PTO Oil Level 71
Crankshaft 86
Installation 87
Removal 86
Crosshead and Connecting Rod Assembly 82
Assembly 83
Bushing Inspection 82
Crosshead Inspection 83
Disassembly 82
Installation 84
Removal 82
Crosshead Pony Rod Seals 75
Installation 76
Removal 75
Replacing the Belts 73
Rod Journal Bearings 78
Inspection 79
Installation 80
Removal 78
UNx Pump 84
Installation 85
Removal 84
T
TRAINING 93
Additional Training Opportunities 93
FS Solutions Training 93
New Start-up Training 93
Safety Training 93
TROUBLESHOOTING 91
W
WATERBLAST SAFETY 1
General Safety Precautions 4
Be prepared 5
Check Connections 4
Check Pressure Ratings 4
Freezing Conditions 5
Inspect Equipment 4
Performing Maintenance Or Repairs 5
Purge The System 5
Read Instructions 4
Rupture Discs 4
Slowly Increase pressure 5
Store Components Properly 5
Test The system 5
Tighten Connections 4
Use The minimum Pressure Required 5
Use Two Operators 4
Recognizing Safety Information 1
Understanding Signal Words 1
Trailer Safety
Avoid Unit Instability 6
Breakaway System 6
Check Brake System 6
Check Lighting 6
Safety Chains 6
Tires and Rims 6
Trailer Hitch 6
Understanding Safety Decals 2
Waterblast Safety Manual 1
WATER TANK AND FILTRATION 39
Water Quality Requirements 39
Water Tank With Filters 40
Filter Cartridge Replacement 42
Filter Inspection 41
Secondary Filter (40K Operation Only) 41
Switch Adjustment 42
Uni-Valve Life 42
To Next Page
Loading...
