Jetter JetMove D203 - Page 31

JetMove D203
Jetter AG 31
Operating Parameters
Mechanical Parameters
Parameter(s) Value(s) Reference
standard
Free falls
withstanding test
Within original packing, the device
withstands dropping over all of its
edges
DIN EN 50178
DIN EN 60068-2-31
Vibration resistance • 10 Hz ... 57 Hz : 0.075 mm
amplitude
• 57 Hz ... 150 Hz: 1.0 g
constant acceleration
• 1 octave per minute, 10
frequency sweeps (sinusoidal),
all three spatial axes
DIN EN 50178
DIN EN 60068-2-6
Class of protection IP 20 DIN EN 60529
Mounting position Vertical
Please make sure there is a
clearance of at least 100 mm
under and above the module -
sufficient ventilation must be
granted.
NOTICE
Measures to avoid damages in transit and storage:
The packaging material and the storage place are to be chosen in a
way that the values given in the above table “Operating Parameters
Mechanical Parameters" on page 31 are kept to.
Operating Parameters
Electrical Safety
Parameter(s) Value(s) Reference
standard
Protection class I DIN EN 61800-5-1
Dielectric strength Protective network conductor and
network logics: 1.7 kV, 5 s
DIN EN 61800-5-1
Insulation Protective network conductor and
network logics: > 1 M at 500 V
DIN EN 61800-5-1
Protective earth
connection
12 V, 10 A, 0.1 DIN EN 61800-5-1
Overvoltage category III DIN EN 61800-5-1
DIN EN 50178
DIN VDE 0110-1
UL 508C
Ω
Ω