JR ProPo XG8 - Function List: PITCH CURVE Continued; PITCH CURVE Examples and Usage

22
PITCHCURVE
EachFunctionintheFunctionList
FunctionExplanation
BecausethebasicoperationconformswiththeThrottleCurve,pleaseensurethatyouclearlyunderstand
theThrottleCurvebeforeusingthisfunction.Thisfunctionadjuststhepitchactionwithregardtothe
throttlestickoperation.Thestickoperationcanbesettoacurvecorrespondingtoamaximumof5point
positions.Inaddition,anEXPO(exponential)functionisalsoincorporatedtoenablethesmoothlinkingof
eachofthepoints.Thiscurvesettingallowssettingofamaximumof6typesineachFlightMode.
•
•
SettingMethod
InputPoints
Theinitialinputsettingpoints
arethreepointssettothe
slow,center,andhighsides.
Toaddapoint,setthestickto
thedesiredpositionandpress
the“ADD”key.Inthesituation
whe re the po int is to be 
deleted,thisshouldbecarried
outusingthe“DEL”key.
Thefigureshowsthesituation
wherethenumberofpoints
hasbeenincreasedto5.
Whenswitchingtothisscreen,forsafetyreasonsyouwillbeaskedwhetherallservosshouldbefixed.Afterconfirmingthis,
thescreenwillchangetotheSettingscreen.Inthesituationwheretheservoshavebeenfixed,inordertoexitfromthe
AdjustingscreenthethrottlestickshouldbesettotheslowsideandtheFlightModeshouldbesetto“NORM”.
•
Theinputpositions(IN)canalsobeadjustedusingthedial.Inaddition,wheninputtingthepointsofthe
outputpositions(OUT),itwillbepossibletoselectandadjustthepointsusingthethrottlestick.
EveniftheHoveringThrottleTrimorHighPitchTrimoperationaffectsthegraph,eachofthepoint
outputvalueswillnotchange.TheOUTnumericalvaluesbelowthegraphwillbeinfluencedbythe
operation.
Afterthesetting,operatetheservosandcarefullyconfirmeachoftheFlightModesettingsbeforeflying.
CautionItems
Caution
FlightMode
UsingFlightModeswitchoperation,thedisplaycanbeswitchedandcurvesettingcanbecarriedout.Inthe
situationwhereextensionswitcheshavebeensetintheFlightMode,6-typeswitchingwillbepossible.
Further,ifthedialispressedinthissituation,settingwillbepossibleoftheswitchingtothegraphofeach
modeeveniftheFlightModeswitchesarenotoperated.
HighPitchTrimLever
Usingtheleveronthesideofthetransmitter,Hpointpitchadjustmentwillbepossible.Becausethiswill
initiallybesetto“INH”,thisshouldbechangedto“ACT”.Thenselectthelevereitherontheleftorrightside
ofthetransmitterusing“INPUT”.Thelevershouldnormallybeleftinthecenterposition,andshouldbe
usedforemergencyadjustment.Inaddition,“RATE”showstheHighPitchlevermovementamount.
•
【PITCURVE】
•
•
•
Helicopter
FlightModePositions
Caution：
Points1,2,and3will
beinfluencedinthe
HoveringPitchTrim
andalsothegraph.
Inaddition,theHigh
PitchTrimwillalso
beinfluencedin
PointH.
CurrentFlightMode
HighPitchLeverUsage
UsageLever
MovementAmount
AdjustingPoint
Display
ThischangesthePoint
ConnectionstoaCurve
EachAdjustingPointInput
PositionandOutputPosition
PointAddition
andDeletion
ThiscopiestheCurve
NumericalDisplayoftheStickInput
PositionandOutputPosition