JR ProPo XG8 - Function List: AILERONS → FLAPS; AILERONS → FLAPS (AILE FLAP) Settings

33
SNAPROLL
EachFunctionintheFunctionList
FunctionExplanation
ThisisafunctionforeasilycarryingoutSnapRolls.Therearefourtypesofpresets,andnormallyoperationis
carriedoutusingtheSnapswitch.However,Stickswitchesarealsoincorporatedthatautomaticallyentera
SnapRollwhenthestickisoperatedbyafixedamount.Further,itisalsopossibletoselectinwhichFlight
ModestheSnapswitcheswillbeeffective.
•
SettingMethod
First,releasetheINHsettingandswitchtothefunctionscreen.Rotatethedialtoselecttheitems,then
pressthedialtodisplaythesettingbox.
Initially,selectthe4typesofpresets.InthesituationwheretheStickswitchesaretobeused,setthevalues
foreachcontrolsurfacewheretheswitcheswillswitchON.Whenstickoperationsexceedingthesevalues
aresatisfiedsimultaneously,theSnapRollwillbeimplemented.InordertousetheSnapswitch,“SNAP
SW”onPage2shouldbesetto“ACT”.InthesituationwheretheFlightModeswitchhasbeenset,thiswill
bedisplayedattherightofthescreen.Ifthisissetto“ON”,theSnapswitchwillbeeffectiveregardlessof
theFlightMode.SettheFlightModesinwhichthefunctionwillbeeffective.
【SNAPROLL】
●Page1
•
Airplane
・Actuallyoperatetheservosandcarefullyconfirmthesettingsbeforeflying.
・Inthesituationwherethetransmitterisbeingusedasatrainer,this
functionwillnotoperate.
CautionItems
Thisselectsthepresets.
OperationCondition
OperationCondition
ThissetstheconditionsthatsettheStickswitchestoON.
“INH”meansthatvalueshavenotbeenset.
Thissetsthepositionsofeachcontrolsurfacewhen
movementhastakenplace.
RIGHT-DOWN
RIGHT-UP
LEFT-DOWN
LEFT-UP
RightDownSnapRoll
RightUpSnapRoll
LeftDownSnapRoll
LeftUpSnapRoll
S.ROLL0
S.ROLL1
S.ROLL2
S.ROLL3
L100%
L100% R100%
R100%
U100%
U100%
D100%
D100%
L100%
L100%
R100%
R100%
AILE
ELEV
RUDD
InitialSettingValues
●Page2
TousetheSnapswitch,thisshouldbesetto“ACT”.
ThiswillbedisplayediftheFlightModehasbeen
set.SetthepositionsinwhichtheSnapswitchwill
beeffective.IfONisset,theswitchwillbeeffective
inallpositions.
□meanstheswitchisOFF,while■meansthe
switchisON.