JR ProPo XG8 - Function List: SWASH MIXING; SWASH MIXING (SWASH MIX) Settings

29
THROTTLEHOLD
EachFunctionintheFunctionList
FunctionExplanation
ThisisafunctionforautorotationlandingthatcanfixtheThrottleServoatthepositionwheretheengine
iscut.Usingselectedswitches,theenginecanbefixedatanoptionalslowposition.Further,thereisalso
aStickAutofunctionthatallowsswitchingoftheservototheHoldpositionwhenthestickisloweredto
anoptionalposition.
•
SettingMethod
FirstsetthefunctiontoACT.ThenadjusttheThrottletothepositionwhereyouwishHoldtobeapplied.
TheusageswitchwillbesettotheHoldswitchasstandard.Further,if“STICKAUTO”isset,theservowill
changetotheHoldpositionwhenthestickhasbeenloweredtothisposition.Additionally,itwillalsobe
possibletosetadelaytopreventthesuddenincreaseinenginerotationswhentheHoldswitchhasbeen
settoOFF.Notonlybylookingatthescreen,butviewingtheactualservooperationwillalloweasyunder-
standing.
•
UsingtheCLRkey,itwillbepossibletocarryoutresettoINHortheinitialvalues.
IftheHoldDelayisset,thesettingsintheServoSpeedfunctionwillbecancelled.
•
•
Hints
【THROHOLD】
Actuallyoperatetheservosandcarefullyconfirmthesettingsbeforeflying.
●WhentheswitchhasbeensettoON,ifthestickisloweredtheservowilloperateuntilthesetposition
isreached.
CautionItem
Helicopter
OperationCondition
StickAutoFunction
Thisisthestickposition
whereHoldisautomatically
applied.
Inordertousethefunction,
INHshouldbechangedtoACT.
PositionthathasbeenSet
Adjustthisto
theposition
wherethe
carbwillclose.
Thisallows
settingofthe
delaywhen
Holdhasbeen
settoOFF.
TotheSwitch
SettingScreen