JR ProPo XG8 - Function List: THROTTLE HOLD; THROTTLE HOLD (THRO HOLD) Settings

28
THROTTLETRIM
EachFunctionintheFunctionList
FunctionExplanation
ThisfunctionsetstheThrottleTrimmovement,andaThrottleCutfunctionisprovidedforcuttingthe
engine.ThereisaTrimMemoryfunctionforcuttingtheengineusingtheTrim.
Notethatforairplanes,anIdleAdjustfunctionisalsoincorporatedthatallowsseparatedetailedsettingof
theidlingposition.
•
SettingMethod
TheCutfunctioncanbeusedonlywitheithertheThrottleCutortheTrimMemory.IftheThrottleCutisset
toACT,theTrimMemorywillbeforciblysettoINH.Onthescreenrotatethedialtomovetoandselectthe
settingitem(inversedisplay),thenpressthedialtosettheitem.NotethatanIdlingAdjustfunctionthat
allowssettingofIdleUpandDownforairplanemodelswillbeshownonPage3.
•
Pleasecarefullyconfirmwhetherthelinkagewilllockwhenthecarbisclosed.
TheswitchnamesontheSwitchSelectionscreenwilldifferslightlyaccordingtothemodeltype.
•
•
Hints
【THROTRIM】
●ThrottleCutScreen(Page1)
IfthefunctionissettoONandthestickislowered,thecarbwillcloseandtheservowillmovetoreachthesetposition.
●TrimMemoryScreen(Page2)
WhentheTrimisloweredinasingleaction,thetrimpositionimmediatelypriortothemovementwillbememorized,
andwhenthetrimisraisedagain,thetrimwillmomentarilyreturntothememorizedposition.Thememorizedposition
willbemarkedontheTrimdisplay.
CautionItem
Helicopter
Airplane
●IdlingAdjustmentScreen(Page3)
TheidlingpositionduringStickSlowcanbegivenseparatedetailedsettingsusingtheswitches.
OperationConditioninthisFunction
IdlingPositionAdjustment
Inordertousethefunction,aftersetting
theThrottleCutfunctiontoINH,setthe
TrimMemorytoACTinthisfunction.
ThrottleCutwillonlybeeffectiveinthesituationwheretheFlightModeinahelicopterhasbeensetto
“NORMAL”.
FunctionOperationCondition
Inordertousethefunction,
INHshouldbechangedtoACT.
PositionthathasbeenSet
Adjustthisto
theposition
wherethecarb
willclose.
TheSwitchOperation
TimeLagcanbeset.
TotheSwitch
SettingScreen
TotheSwitch
SettingScreen
BecausethisfunctionwillbeprioritizedwhenThrottleCutis
settoACT,theTrimMemoryonPage2cannotbesettoACT.