JR ProPo XG8 - Function List: THROTTLE TRIM; THROTTLE TRIM (THRO TRIM) Settings

27
THROTTLEMIXING
FunctionExplanation
Byoperatingeachcontrolsurface,therotorrotationmaybereducedduetoloading.Thisfunctionisa
mixingfunctionforimplementingacorrectionforthiseffect.Itwillallowrecreationoftherotationspeed
correctioncarriedoutautomaticallybythegovernor.Itwillalsobepossibletocarryoutsettingusingsepa-
rateswitchesofthemixingfromeachofthecontrolsurfaces,comprisingtheailerons,elevators,and
rudder.
•
SettingMethod
Thescreencoverstwopages,andeachofthecorrectionmixingwillbeseparatelydividedanddisplayed.For
allofthemixes,itwillbepossibletoswitchON/OFFusingindependentswitches.Aftersettingtheswitches,
pleaseconfirmthedisplayoftheoperationcondition.Thensetthecorrectionamountstothethrottleusing
eachofthestickoperationdirections.Thestickshouldbesettowhicheverdirectiontherotorrotation
increaseswhentheoperationiscarriedout.
•
Duringnumericalvaluesetting,theCLRkeycanbeusedtoresetthevalue.
IfthedialisrotatedwhilepressingandholdingtheFunctionkey,thenumericalvaluescanbechangedat10times
normalspeed.
Asaroughguidetothesettingvalues,itisrecommendedthattheaileronsandelevatorsshouldbesetto10-30,
andtheruddershouldstartfromL10/R15%.
•
•
•
Hints
【MIX→THRO】
EachFunctionintheFunctionList
Whenusingagovernor,thisfunctionwillnotberequired,andthenumericalvaluesshouldall
besettozero.
Actuallyoperatetheservosandcarefullyconfirmthesettingsbeforeflying.
•
•
CautionItems
Helicopter
Page２
TotheSwitch
SelectingScreen
OperationCondition
Page１
CorrectionValuein
EachDirection
MixingName
Inthisbox,thereisonetypeof
MixingAdjustingscreen.