Chapter 2 OPERATIONS
2.7 SOFT KEY OPERATION
2-39
2
INSTRUCTION MANUAL
Reference:
When the number of targets tracked has reached to the maximum (10 targets), any new
target is not acquired.
Delete the unnecessary targets, then acquire new targets.
Manual acquisition (Operation with the [ENT] key)
Target can be acquired by the [ENT] key operation without displaying the soft key menu.
Note:
If operating with the [ENT] key when the soft key menu is closed, the equipment
performs the followings:
On the AIS symbol: Opens the AIS soft key and the numerical display of AIS.
On the TT symbol: Opens the TT soft key and the numerical display of TT.
Not on the AIS or TT symbol:
Opens the TT soft key, it will be acquired.
If operating with the [ENT] key when the AIS symbol overlaps the TT symbol,
the numerical display of AIS symbol takes priority.
1 Press the cursor keys to select the target for acquisition with the cursor, then
press the [ENT] key.
An initial acquisition symbol appears, and the "TT" soft key is displayed.
After one minute elapses, the target tracking symbol and vector are displayed.
Reference:
When operating the [ENT] key on a TT symbol, the "TT" soft key and the target tracking
data are displayed.
When operating the [ENT] key on an AIS symbol, the "AIS" soft key and the selected
AIS data (numerical display) are displayed.
Automatic acquisition
1 Perform the procedure as shown below to start automatic acquisition.
Open Alarm1 from the soft key menu.
Soft key 1: On
Soft key 2: AZ1
To Next Page
Loading...
Need help?
General
