EasyManuals Logo

Juniper EX2200 Complete Hardware Guide

Juniper EX2200
176 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #103 background imageLoading...
Page #103 background image
CHAPTER 11
Performing Initial Configuration
EX2200 Switch Default Configuration on page 83
Connecting and Configuring an EX Series Switch (CLI Procedure) on page 87
Connecting and Configuring an EX Series Switch (J-Web Procedure) on page 89
EX2200 Switch Default Configuration
Each EX Series switch is programmed with a factory default configuration that contains
the values set for each configuration parameter when a switch is shipped. The default
configuration file for an EX2200 switch configures Ethernet switching and storm control
on all interfaces, configures Power over Ethernet (PoE) on all interfaces of models that
provide PoE, and enables the LLDP, LLDP-MED, and RSTP protocols and IGMP snooping.
When you commit changes to the configuration, a new configuration file is created that
becomes the active configuration. You can always revert to the factory default
configuration. See Reverting to the Default Factory Configuration for the EX Series Switch.
The following factory default configuration file is for an EX2200 switch with 24 ports, all
of which have PoE capability:
NOTE: For models that have more than 24 ports, this default configuration
file has more interfaces. For models without PoE, the poe stanza does not
appear. All models have four uplink ports as listedbelow, ge-0/1/0 to ge-0/1/3.
ethernet-switching-options {
storm-control {
interface all {
level 50;
}
}
}
protocols {
igmp-snooping {
vlan all;
}
lldp {
interface all;
}
83Copyright © 2010, Juniper Networks, Inc.

Table of Contents

Other manuals for Juniper EX2200

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Juniper EX2200 and is the answer not in the manual?

Juniper EX2200 Specifications

General IconGeneral
Throughput77 Mpps
MAC address table8000 entries
Jumbo frames supportYes
Number of VLANs1024
Networking standards-
Switch typeManaged
SFP module slots quantity4
Installed SFP modules quantity0
Basic switching RJ-45 Ethernet ports quantity48
StackableNo
Product colorBlack
Power consumption (typical)100 W
Operating altitude0 - 3048 m
Non-operating altitude0 - 4877 m
Storage temperature (T-T)-40 - 70 °C
Operating temperature (T-T)0 - 45 °C
Storage relative humidity (H-H)0 - 95 %
Operating relative humidity (H-H)10 - 85 %
Weight and Dimensions IconWeight and Dimensions
Depth254 mm
Width441 mm
Height43 mm
Weight3600 g

Related product manuals