Juniper EX2200 Complete Hardware Guide

CHAPTER 6
Cable Specifications
•
Network Cable Specifications for EX2200 Switches on page 45
Network Cable Specifications for EX2200 Switches
EX2200 switches have interfaces that use various types of network cables.
For instructions on connecting the switch to a network for out-of-band management
using an Ethernet cable with an RJ-45 connector, see “Connecting an EX Series Switch
to a Network for Out-of-Band Management” on page 74.
For instructions on connecting the switch to a management console using an Ethernet
cable with an RJ-45 connector, see “Connecting an EX Series Switch to a Management
Console” on page 76.
For instructions on connecting a fiber-optic cable to the switch, see “Connecting a
Fiber-Optic Cable to an EX Series Switch” on page 81.
Related
Documentation
• Management Port Connector Pinout Information for an EX2200 Switch on page 22
• Console Port Connector Pinout Information for an EX Series Switch on page 21
• Front Panel of an EX2200 Switch on page 5
• Rear Panel of an EX2200 Switch on page 6
45Copyright © 2010, Juniper Networks, Inc.

Juniper EX2200 Specifications

General

Throughput	77 Mpps
MAC address table	8000 entries
Jumbo frames support	Yes
Number of VLANs	1024
Networking standards	-
Switch type	Managed
SFP module slots quantity	4
Installed SFP modules quantity	0
Basic switching RJ-45 Ethernet ports quantity	48
Stackable	No
Product color	Black
Power consumption (typical)	100 W
Operating altitude	0 - 3048 m
Non-operating altitude	0 - 4877 m
Storage temperature (T-T)	-40 - 70 °C
Operating temperature (T-T)	0 - 45 °C
Storage relative humidity (H-H)	0 - 95 %
Operating relative humidity (H-H)	10 - 85 %

Weight and Dimensions

Depth	254 mm
Width	441 mm
Height	43 mm
Weight	3600 g