Juniper EX2200 Complete Hardware Guide

Table 14: Optical Interface Support for Fast Ethernet SFP Transceivers in EX2200
Switches (continued)
ValueSpecificationEthernet Standard
EX-SFP-FE20KT15R13Model Number100Base-BX-D
100 MbpsRate
LCConnector Type
SingleFiber Count
1550 nmTransmitter Wavelength
1310 nmReceiver Wavelength
–14 dBmMinimum Launch Power
–8 dBmMaximum Launch Power
–45 dBmMinimum Receiver Sensitivity
–8 dBmMaximum Input Power
SMFFiber Type
9/125 µmCore/Cladding Size
–Modal Bandwidth
20 km (12.4 miles)Distance
Junos OS for EX Series switches, Release 10.1 or laterSoftware required
Related
Documentation
• Front Panel of an EX2200 Switch on page 5
• Installing a Transceiver in an EX Series Switch on page 65
• Removing a Transceiver from an EX Series Switch on page 95
29Copyright © 2010, Juniper Networks, Inc.
Chapter 3: Component Specifications

Juniper EX2200 Specifications

General

Throughput	77 Mpps
MAC address table	8000 entries
Jumbo frames support	Yes
Number of VLANs	1024
Networking standards	-
Switch type	Managed
SFP module slots quantity	4
Installed SFP modules quantity	0
Basic switching RJ-45 Ethernet ports quantity	48
Stackable	No
Product color	Black
Power consumption (typical)	100 W
Operating altitude	0 - 3048 m
Non-operating altitude	0 - 4877 m
Storage temperature (T-T)	-40 - 70 °C
Operating temperature (T-T)	0 - 45 °C
Storage relative humidity (H-H)	0 - 95 %
Operating relative humidity (H-H)	10 - 85 %

Weight and Dimensions

Depth	254 mm
Width	441 mm
Height	43 mm
Weight	3600 g