Juniper NFX250 - Page 134

user@jdm# set virtual-network-functions vnf2 interfaces eth3 mapping vlan members
v10
user@jdm# set virtual-network-functions vnf2 interfaces eth3 mapping vlan members
v20
user@jdm# set virtual-network-functions vnf2 interfaces eth3 mapping vlan members
v30
user@jdm# set virtual-network-functions vnf2 interfaces eth3 mapping vlan mode
trunk
user@jdm# set virtual-network-functions vnf4 interfaces eth4 mapping vlan members
v30
user@jdm# set virtual-network-functions vnf5 interfaces eth5 mapping vlan members
v50
user@jdm# set virtual-network-functions vnf5 interfaces eth6
user@jdm# set virtual-network-functions vnf6 interfaces eth7
3. Configure cross-connect:
•
Configure VLAN-based cross-connect:
user@jdm# set cross-connect vlan-cross-connect-name virtual-network-functions
vnf-name interfaces interface-name vlan-id vlan-id
user@jdm# set cross-connect c1 virtual-network-functions vnf1 interfaces eth2
vlan-id 10
user@jdm# set cross-connect c1 virtual-network-functions vnf4 interfaces eth2
vlan-id 10
•
Configure unconditional cross-connect
user@jdm# set cross-connect unconditional-cross-connect-name
virtual-network-functions vnf-name interfaces interface-name
user@jdm# set cross-connect c2 virtual-network-functions vnf1 interfaces eth1
user@jdm# set cross-connect c2 virtual-network-functions vnf5 interfaces eth5
•
Configure cross-connect with VLAN SWAP operation enabled:
user@jdm# set cross-connect swap-cross-connect-name virtual-network-functions
vnf-name interfaces interface-name vlan-id vlan-id
user@jdm# set cross-connect c1 virtual-network-functions vnf1 interfaces eth1
vlan-id 10
user@jdm# set cross-connect c1 virtual-network-functions vnf4 interfaces eth4
vlan-id 30
•
Configure cross-connect with VLAN PUSH or POP operation enabled:
user@jdm# set cross-connect push-pop-cross-connect-name
virtual-network-functions vnf-name interfaces interface-name vlan-id vlan-id
user@jdm# set cross-connect push-pop-cross-connect-name
virtual-network-functions vnf-name interfaces interface-name
user@jdm# set cross-connect c3 virtual-network-functions vnf1 interfaces eth1
vlan-id 10
user@jdm# set cross-connect c3 virtual-network-functions vnf6 interfaces eth7
•
Configure native VLAN traffic on cross-connect
user@jdm# set cross-connect push-pop cross-connect-name
virtual-network-functions vnf-name interfaces interface-name vlan-id vlan-id
user@jdm# set cross-connect c2 virtual-network-functions vnf1 interfaces eth1
vlan-id none
Copyright © 2017, Juniper Networks, Inc.116
JDM User Guide for NFX250 Network Services Platform