On a disaggregated Junos OS platform, the out-of-band management interface for
Hypervisor is named eth0br. The eth0br interface has a direct connection to the dedicated
Ethernet management port on the front panel of the device.
•
Configuring the Out-of-Band Management Interface with IPv4 Addressing for
Hypervisor on page 37
•
Configuring the Out-of-Band Management Interface with IPv6 Addressing for
Hypervisor on page 37
Configuring the Out-of-Band Management Interface with IPv4 Addressing for Hypervisor
To configure the management interface with IPv4 addressing:
1. Configure the logical interface and the IP address:
root@jdm# set host-os interfaces eth0br unit 0 family inet address
ipv4-address/mask
2. Set the default route:
root@jdm# set host-os routing-options static route 0.0.0.0/0 next-hop
gateway-ipv4-address
Configuring the Out-of-Band Management Interface with IPv6 Addressing for Hypervisor
To configure the management interface with IPv6 addressing:
1. Configure the logical interface and the IP address:
root@jdm# set host-os interfaces eth0br unit 0 family inet6 address
ipv6-address/mask
2. Set the default route:
root@jdm# set host-os routing-options static route ::/0 next-hop
gateway-ipv6-address
Configuring SSH Service and NETCONF-Over-SSH Connections for Remote Access to
the Disaggregated Junos OS Platform
You can configure the disaggregated Junos OS platform to accept NETCONF sessions
over SSH as an access service.
To do so:
1. Access the system services SSH configuration:
[edit]
user@jdm#set system services netconf ssh
2. Configure the TCP port used for NETCONF-over-SSH connections:
[edit system services netconf ssh]
user@jdm#user@jdm# port port-number
37Copyright © 2017, Juniper Networks, Inc.
Chapter 3: Management
To Next Page
Loading...
