Juniper NFX250 - Accessing the JDM CLI; Accessing the JDM Shell; Accessing the JCP Prompt from the JDM CLI; Accessing the Hypervisor from the JDM CLI

•
Accessing the Hypervisor from the JDM CLI on page 29
•
Accessing the ipsec-nm from the JDM CLI on page 30
Accessing the JDM CLI
You are in operational mode in the JDM CLI if you see the @jdm> prompt. The JDM CLI
also includes the configuration prompt @jdm#, which can be accessed by entering the
configure command at the JDM CLI operational mode prompt.
By default, most logins to a disaggregated Junos OS platform take the user to the
operational mode in the JDM CLI prompt.
The JDM CLI prompt can also be accessed from the JDM shell.
To access the JDM CLI from the JDM shell, enter the cli command at the JDM shell prompt:
root@jdm:~# cli
root@jdm>
Accessing the JDM Shell
Be default, you are placed in the JDM shell when you login to the console port as the root
user. The JDM shell uses the ~# prompt.
To access the JDM shell from the JDM CLI, enter the start shell command at the JDM CLI
prompt:
root@jdm> start shell
jdm:~#
Accessing the JCP Prompt from the JDM CLI
To access the JCP prompt from the JDM CLI, enter the ssh vjunos0 statement at the JDM
CLI prompt:
root@jdm> ssh vjunos0
The authenticity of host 'vjunos0 (192.168.1.2)' can't be established.
ECDSA key fingerprint is 18:83:1f:95:88:db:1b:75:9f:07:ce:2c:4a:45:a3:b0.
Are you sure you want to continue connecting (yes/no)? yes
Warning: Permanently added 'vjunos0,192.168.1.2' (ECDSA) to the list of known
hosts.
Password:
Last login: Thu Oct 8 09:47:42 2015
--- JUNOS 15.1I20150824_0501 built 2015-08-24 05:13:01 UTC
root@:RE:0% cli
root>
Accessing the Hypervisor from the JDM CLI
To access the Hypervisor from the JDM CLI, enter the ssh hypervisor statement at the
JDM CLI prompt:
root@jdm> ssh hypervisor
Last login: Sun Jan 18 15:01:55 2015 from jdm
29Copyright © 2017, Juniper Networks, Inc.
Chapter 3: Management