Juniper NFX250 - Installation; Managing Software Installation on NFX250 Network Services Platform

CHAPTER 2
Installation
•
Managing Software Installation on NFX250 Network Services Platform on page 19
•
Upgrading an Image on the Disaggregated Junos OS Platform on page 20
•
Reverting the System to the Factory-Default Configuration on page 23
•
Rebooting the System on page 23
Managing Software Installation on NFX250 Network Services Platform
This topic lists the commands to be used for installing a software package and upgrading
an image on NFX250 Network Services Platform and rebooting the NFX250 platform. It
also lists the commands to be used for formatting and reverting the system to factory
state.
To install a new package on the NFX250 Network Services Platform:
[edit]
user@jdm> request system software add package [reboot]
Reboot is an option to reboot the device after installing the new software package.
Replace package with the following path:
For a software package in a local directory on the platform—/var/tmp/package.tgz
To reboot the platform:
[edit]
user@jdm> request system reboot
To format the system by deleting all user data, configuration details, and reinstall current
software on the NFX250 Network Services platform:
user@jdm> request system zeroize
To format the system by deleting all user data, configuration details, and to upgrade the
software on the NFX250 Network Services platform:
user@jdm> request system software add package clean-install
19Copyright © 2017, Juniper Networks, Inc.