•
Address Books
•
Autokey IKE
•
Hostname
•
VLAN
•
Static Routing
•
Media MTU
•
Root Password Encryption
•
Security Zones and Interfaces
•
Host Inbound Traffic
Configuring IPSec-NM Interfaces
To enable IPSec-NM on a LAN or WAN, you must configure interfaces to provide network
connectivity and data flow.
NOTE: Ensure that connectivity to the host is not lost during the configuration
process.
To configure IPSec-NM interface, complete the following steps:
1. Create a logical interface with a VLAN ID:
root@ipsec-nm# set interfaces interface-name unit interface-logical-unit-number vlan-id
vlan-id
2. Assign an IPv4 address to the logical interface:
root@ipsec-nm# set interfaces interface-name unit interface-logical-unit-number family inet
address interface-address
3. Assign an IPv6 address to the logical interface:
root@ipsec-nm# set interfaces interface-name unit interface-logical-unit-number family inet6
address interface-address
4. Enable VLAN tagging support on the logical interface:
root@ipsec-nm# set interfaces interface-name vlan-tagging
171Copyright © 2017, Juniper Networks, Inc.
Chapter 8: Understanding IPSec-NM
To Next Page
Loading...
